Search the Community
Showing results for tags 'mash tun and separating'.
Found 1 result
Hi guys, I have posted a few times and I can not thank you enough for all the feed back. I have also had the pleasure of talking to a lot of craft distillers out there and you all have been nothing but helpful. So after having some ideas about still size and type and going over prior setups and just reading and experimenting a lot I decided to change a lot of things and as always I want to run it by some of you guys for some feedback and words of advice. I am looking at a 250 gallon direct fire Alembic still with 1 thumper and a lentil, I like them a lot, they look beautiful and I have always done direct fire anyway so why change now if I am comfortable. I am going with (2) 1000L comipak fermenters. I am going for a 600 gallon mash tun and I plan on feeding it with a commercial tank less water heater rated at 185F. Here is a quick question, I am trying to calculate the correct size for a mash tun because of all the grain, I think a 600 gallon would be enough as I use 2lb/gal As far as separating grain, I always did it by hand after the mash but this would be silly with such a large volume so what is a good way to separate after the mash and transport to the fermenter. I have been looking at screener separators but was curious to see if a false bottom would be good enough. I plan on using the Yamada NDP-20BSE-FDA for transfering between the mash-fermenter-still I will also be using this pump for circulation in the still during operation Does anyone know a good high alcohol explosion proof pump? Oh and I as I have been reading about the amount of measuring you have to do I have been talking to Fred over at Prime USA scales, my question is how many do you wish you had. I just want to say thank you again in advance. Also, I plan on making vodka, gin, whiskey and brandy (eventually)