deadlywarbler Posted September 6, 2012 Share Posted September 6, 2012 Hi All, I can't seem to find specifications on the Enolmatic vacuum filler. I am needing to fill small 5oz bottles and I cannot seem to figure what the gasket size is for the regular set-up ( or down to what size bottle it will handle). I'm wondering if I need to buy their mignon kit, which is hard to find and expensive! Does anyone know these specs, or does anyone have one of these units they could measure for me? Thanks! Link to comment Share on other sites More sharing options...
deadlywarbler Posted September 6, 2012 Author Share Posted September 6, 2012 By the way, the bottle I am using has an inner diameter of about 15mm. Thanks! Link to comment Share on other sites More sharing options...
jwymore Posted September 6, 2012 Share Posted September 6, 2012 I have a single spigot model Enolmatic filler here and the plastic guide that is below the tapered gasket looks to measure right at 15mm. The bottom of the gasket blends right to this so at the very smallest point it would also be 15mm. Not sure if all models use the same size gasket but it looks like you might be able to squeeze by. Link to comment Share on other sites More sharing options...
deadlywarbler Posted September 9, 2012 Author Share Posted September 9, 2012 jwymore, thanks for getting that measurement out to me! I think my bottle is actually about 15.9mm, so based on that I think you're right, I might be able to get by! Thanks again! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now