Ok... here is the basic design of the 6x manual tapered bottle labeling jig. Cut the diameter of the half circles to match your bottle size at the base where it will sit in the jig, and the neck. If you get a board twice as wide as you need, then cut with a hole saw and rip down the middle and you will have two of these so you can make two jigs. You don't want the bottle too snug, but you also don't want too much wiggle room. the spools for the labels are just plumbing parts. I used a couple of drawer pulls with a string across to line up where the bottom of the label goes. The only othe