Search the Community
Showing results for tags 'hot water'.
Brand New NEVER used Drain Temping valves. Amount- x7 Brand- ThermOmega tech Model-1DTV-140-SS-327 Size- 1" diameter Open @ 140 F - Close @ 130F Max Temp 250F PMO-125 PSIG http://www.thermomegatech.com/product/drain-tempering-valve/ Benefits Compliant with drain temperature limitations of plumbing codes Prevents damage to PVC piping due to over-temperature conditions Minimizes water waste Easy to install Adaptable to almost any drain size Design Features Rugged, clog resistant valve design Install using standard pipe fittings and tools Operates in any orientation Modulates to conserve cooling water Effluent tempering capacity limited only by cold water flow rate through DTV Operation The DTV can be used in applications where a high-temperature discharge flow to a drain or sewer must be tempered with cold water. The DTV is installed into the drain line such that the hot effluent passes over the thermal actuator of the DTV and this thermal actuator controls the cold-water inlet port. If the hot effluent is above the specified set point, the DTV opens to allow injection of cold water. As the hot effluent cools, the DTV automatically modulates to reduce the cold-water inlet flow. At about 10°F below the full open temperature, the cold-water inlet is fully closed to conserve water. The DTV provides a convenient, economical, and easy to use a method of tempering hot effluent flows. Since the DTV is open only when the effluent exceeds the specified set point temperature, it also conserves water by automatically turning off cold water when not needed. Please contact me for more information or pictures. These items can be mailed/shipped through any shipping service/provider. *Asking Price is $350 each, there are 7 for sale DTV-Sell-sheet.pdf DTV.pdf IMG_3510.HEIC IMG_3511.HEIC DTV_IMI.pdf IMG_3512.HEIC
I am selling a used "Shell and tube condenser" instant hot water heater manufactured by Jet-Vac. This hot water heater is steam powered off your boiler and allows you to make unlimited amounts of hot water up to 211 degrees at up 30GPM. It is big, about 6~7 feet tall and all stainless. Built in 1994 the nameplate says it is rated to 30 GPM. It was included with my boiler when I bought it (15hp Fulton) but I don't need it. I've seen it in operation but have not used it myself. The outside insulation jacket is cracked and split in a couple of places from moving it around. Included are the NTP flanges to hook into a system as well as a custom built stand. In the pic you can see me standing next to the heater (the heater is about 6 ft tall) and the custom made steel stand is next to it. Its rated up to 75psi and the original owner had it running at 60psi, lower pressures will yield lower hot water flow rates. A pressure regulator, relief valve and tempering valve are NOT included. You must use a tempering/mixing valve after the heater to get the exact water temp you need. See attached pics for more info. Asking $2000 as I just don't need it. Shipping not included and it will need to crated. For more Contact Kevin at 603-512-0455. Located in Seabrook, NH