Jump to content

ENOS T3 Labeling Machine - Help?


tophat36

Recommended Posts

Does anyone have experience with this machine? The bottle gets to label roller and the machine just puts labels on nonstop without disengaging the bottle, it just stays there and keeps spinning.  The eye appears to be working correctly but might not be telling the computer to go to the next bottle and push it through.  Any advice or wisdom? We have a manual but it hasn’t been helpful...thank you in advance!

Link to comment
Share on other sites

  • 6 years later...

We have this system.

 

A few suggestions:

You need to set the sensors properly on the label infeed:  Either 1 cm from the beginning of the label or 1 cm from the end.  That is usually the main culprit.  It's feeding non stop because it cannot determine where the label gap is.

If you're doing a two label application, make sure the settings reflect that. 

Make sure the label spool is tight/has some resistance.  Sometimes it will increase "slack" in the label feed and cause it to misfeed.  

Make sure the labels have enough gap/space between them.  If you have a clear label backing, this can be problematic.  

Here is a senor adjustment how to: 

 

 

Hope this helps!

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...